Powerloss/reset when current exceeds 6A

TRU

The board gets power. I can measure the voltage at the hotend heater connection. The problem occurs when more components are switched on.

Phaedrux

Do you see any visible damage to the board or connectors? Melting scorch marks? Loose fittings?

dc42

Check that the screws in the VIN terminal block are still tight.

TRU

i had to replace the Main terminal block, therefore the solderingspots are not pristine anymore.
I did some test cycles the last hours.(each of the 4 scenarios were tested 20 times) it is always the same:

Running all three steppers (homing, calibration, random moves) - no problem
Heating the hotend alone - no problem
Hotend with steppers - instant powerloss (short flicker of LEDs and webinterface disconnect)
Activation of heatbed - always as with Hotend and steppers

(while doing this I monitored the voltage between VIN & GND - there was no voltage drop whatsoever)

So I can rule out a loose connection.

dc42

@tru said in Powerloss/reset when current exceeds 6A:

i had to replace the Main terminal block, therefore the solderingspots are not pristine anymore.
I did some test cycles the last hours.(each of the 4 scenarios were tested 20 times) it is always the same:

Running all three steppers (homing, calibration, random moves) - no problem

Heating the hotend alone - no problem

Hotend with steppers - instant powerloss (short flicker of LEDs and webinterface disconnect)

Activation of heatbed - always as with Hotend and steppers

(while doing this I monitored the voltage between VIN & GND - there was no voltage drop whatsoever)

So I can rule out a loose connection.

It sounds extremely like a bad connection to me. Where did you measure the voltage between VIN and ground?

Have you tried monitoring the VIN voltage reported by the Duet, when you run the stepper motors and when you heat the hot end?

TRU

Good evening,

the duet wifi stopped working completely, so I removed the terminal block and found smoldered or burned spots beneath it and on the block itself. I have ordered a new one. Additionally I would like to check the fuses, but i cant find them or their values in the wiki.

Regards
TRU

dc42

@tru said in Powerloss/reset when current exceeds 6A:

Additionally I would like to check the fuses, but i cant find them or their values in the wiki.

https://duet3d.dozuki.com/Wiki/Connector_and_spare_part_numbers

TRU

Good evening,

I changed the terminal block and the problem is still there.
As soon as at least one heating device gets activated the board behaves as if the reset button has been pushed.

I can still print (without heatbed), when I power the hotend directly with a PSU and a mosfet (IRF520) with the signal from the E0 terminal block.

Is it possible to send in the board for a cost estimate/repair?

Regards
TRU

dc42

How old is your Duet, and which country are you in?

TRU

Good evening,

It is a duet wifi (should be v1.03), which I bought 11 month ago at makerdise.
I am from germany.

Regards
TRU

dc42

I have emailed you.