Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. Tags
    3. powerloss
    Log in to post
    • All categories
    • curieosundefined

      M911, Print not Resuming After Voltage Threshold is Reached

      Tuning and tweaking
      • powerloss sbc mode • • curieos
      17
      0
      Votes
      17
      Posts
      731
      Views

      infiniteloopundefined

      @curieos said in M911, Print not Resuming After Voltage Threshold is Reached:

      That is highly unlikely, the buffer provides enough power for the M911 codes to be run to completion

      Sorry, I forgot:

      this is supposed to be a large, industrial machine that offers power loss recovery as a selling point.

      As a Pro, you sure have monitored the 24V and 3.3V rails’ behaviour on the event of sudden power loss - a cheapo two-channel scope is all you need. What I know for sure is that the resume.g file is generated by RRF on an undervoltage event as long as the Duet’s electronics have sufficient power to stay alive long enough. And I can assure you: 4 secs are long enough.

      OTOH, your 3-4 seconds buffer supplies 22V, so it is meant to feed all steppers and heaters (excluding the bed) as well? These devices are operated by strong pulses - a voltage plot over these 3-4 secs might be interesting 😊

    • Grudairianundefined

      14 Volts?

      Duet Hardware and wiring
      • powerloss voltage • • Grudairian
      14
      0
      Votes
      14
      Posts
      1.4k
      Views

      dc42undefined

      @grudairian, increasing voltage from 12V to 14V will increase heater power by 36%. So definitely worth trying if bed heating is too slow. Remember to re-run heater tuning on both hot end and bed.

    • TRUundefined

      Powerloss/reset when current exceeds 6A

      Duet Hardware and wiring
      • powerloss troubleshooting • • TRU
      13
      0
      Votes
      13
      Posts
      1.6k
      Views

      dc42undefined

      I have emailed you.