Problems installing the IR Probe on the Duet Ethernet

MikeB · 6 Dec 2018, 00:05

i have the same issue. ...

; Z-Probe
M574 Z1 S2 ; Set endstops controlled by probe
M558 P1 H5 F120 T6000 ; Set Z probe type to modulated and the dive height + speeds
G31 P500 X0 Y0 Z1.0 ; Set Z probe trigger value, offset and trigger height
M557 X40:260 Y40:260 S42.5 ; Define mesh grid

this is Cartesian duet wifi 2.0
please help???

MikeB · 6 Dec 2018, 00:08

it seems to just light up one time when i plug in usb.

MikeB · 9 Dec 2018, 15:48

guess no reply means tuff _____.

dc42 · 9 Dec 2018, 16:38

@mikeb said in Problems installing the IR Probe on the Duet Ethernet:

it seems to just light up one time when i plug in usb.

Do you mean that the LED on the IR sensor flashes once, or lights up and stays lit? How bright is it? A continuous dimly-lit LED on the IR sensor means that it isn't getting the Vcc supply.

MikeB · 9 Dec 2018, 17:05

it looks normal brightness. it lights up once and then goes off. never lights up again. been over everything ten times. now z motors just buzz. getting discuraged. spent all this money...

elmoret · 10 Dec 2018, 17:02

Could you upload a few photos showing how you have it wired? (the connectors at each end of the cable)

MikeB · 10 Dec 2018, 21:21

aidar · 12 Oct 2018, 21:38

Looks like you wires are connected to Duet incorrectly. Red wire (+3.3v) should be where your green (or is it blue) wire is, next pin should be free, then ground (black one) and finally closest to Paneldue connector should be green wire. Or to make it simple, you have to turn your connector 180 degrees.

MikeB · 12 Dec 2018, 02:46

MikeB · 12 Dec 2018, 02:48

@mikeb guess e3d messed up.

MikeB · 12 Dec 2018, 02:51

@aidar i thank you very much !

MikeB · 12 Dec 2018, 03:03

you fixed me bud. i owe you one! thanks again!

BLV · 12 Dec 2018, 04:54

I have to say that David's mini IR module is the best height sensor to use with the duet board. I am getting the most accurate readings..

MikeB · 12 Dec 2018, 05:10

@blv how is your bed setup? PICS?
and i agree is does seem to be accurate but i have much to learn...

dc42 · 13 Dec 2018, 12:41

@blv said in Problems installing the IR Probe on the Duet Ethernet:

I have to say that David's mini IR module is the best height sensor to use with the duet board. I am getting the most accurate readings..

Thanks! But in fairness, there are some surfaces that it doesn't work well with, e.g. glass with a coating of glue stick or hairspray on top.

MikeB · 15 Dec 2018, 03:10

@dc42 yes i have read about this. i bought black paper build surface that it seems to work well with. im fighting z axes shutter right now... no printing at all.