is it alive or dead

dc42

If the wifi firmware is already on the SD card, sending M997 S1 will install it.

yaman

dc42

Set the line ending in YAT to LF only (in the Text Settings), then you will be able to read the responses more easily.

yaman

yaman

This post is deleted!

yaman

@dc42

0_1548273818074_Screenshot 2019-01-23 12.00.41.png

dc42

You didn't set the line ending in YAT to LF Only, so the response to M997 S1 was truncated, and I can't tell whether the firmware update succeeded or not.

yaman

@dc42 said in is it alive or dead:

truncated

0_1548274436727_Screenshot 2019-01-23 11.07.jpg

dc42

@yaman, you still haven't set the YAT line ending properly. Go to Terminal, Settings, Text Settings, EOL Sequence.

yaman

yaman

@dc42 0_1548275213107_Screenshot 2019-01-23 12.26.37.png

yaman

@dc42 0_1548312914417_Screenshot 2019-01-23 22.54.16.png

0_1548312926957_Screenshot 2019-01-23 22.54.30.png

yaman

0_1548313169786_Screenshot 2019-01-23 22.54.30.png
is it disable or not function ?

yaman

yaman

@dc42
I think the WIFI module is dead
right now I make order new controller
but entail it's arrive can I replace with this
https://www.amazon.com/gp/product/B07BRQTLZG/ref=ox_sc_act_title_1?smid=A144J8BE3R51KJ&psc=1
is will work if I change the old one with this ?

dc42

I agree, the WiFi module is dead, because it failed to connect at all the baud rates that were tried. With the right tools (hot air desoldering equipment or very low melting point solder), it can be removed and then replaced. Don't try to remove it without one of those.

The ESP-12S that you linked to is the correct module. Or you can use the ESP-07S + external antenna, such as https://www.amazon.com/Chironal-ESP8266-ESP-07S-Wireless-Transceiver/dp/B07M7L1CGL/ref=sr_1_12?s=electronics&ie=UTF8&qid=1548322176&sr=1-12&keywords=esp-07s.

Anidal

This post is deleted!

yaman

@dc42
so after this disaster what's better option and ( safer ) to put capacitive sensor NPN 24 v
end stop E1 or in z probe ?

yaman

after search I find this diagram is it will work :
My power in 24 Vdc so the capacitive sensor NPN 24 v

blue for +
brown for -
black for signal

0_1548335312812_ capacitive sensor NPN 24 v.jpg

dc42

That diagram is good if your Duet is PCB revision 1.04. With earlier PCB revisions, we recommend using a diode as described in the wiki page con connecting z probes.