Laser Engraving picture
I'm In the middle of design my second F.D.M printer (delta type) with duet controller
and I'm thinking to add closed-loop stepper motor either the stepper motor to get maximum speed and reduce the noise to minimum.
the machine size (delta print XL) 1000X500 print area Round 300
so my questions are :
1-Is Expansion Header Breakout Board enough or I need something else ?
the close loop stepper motor +driver
2- is there anyone has Experience with closed-loop stepper motor ?
Right now I'm at Version 2.0.0-RC2
so any Suggestions for good version work fine with 3dprinter and Laser ?
thanks for you replay
but this circuit will not work in my case because I don't have Fan 2
fan 2 I use it for tool 2
I have heater 6 -7 with 5v PWM