Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order
    1. Home
    2. Tags
    3. voltage
    Log in to post
    • All categories
    • niocio01

      Ignore undervoltage condition, while PSU off
      Duet Web Control • pson voltage warning ignore • • niocio01

      4
      0
      Votes
      4
      Posts
      95
      Views

      niocio01

      @gloomyandy Yes. I get it only once, when I turn the PSU off, which I expected.
      It's not a big deal, just a minor annoyance.
      I just wish to keep my logs clean. 😉

    • e4d

      Low voltage on Duet3 6CH IO pins
      Duet Hardware and wiring • duet3 6hc voltage • • e4d

      7
      0
      Votes
      7
      Posts
      182
      Views

      e4d

      @jay_s_uk I had success with your proposition, thank you !

    • jMaddrell

      Toolboard 1.1 IO pins voltage tolerance
      Duet Hardware and wiring • toolboard voltage • • jMaddrell

      3
      0
      Votes
      3
      Posts
      139
      Views

      jMaddrell

      @phaedrux thanks much appreciated

    • Wurke

      Inductive sensor as end stop. Is it possible and how?
      Duet Hardware and wiring • duet 2 wifi sensor voltage • • Wurke

      9
      0
      Votes
      9
      Posts
      353
      Views

      A Former User

      @bonjipoo you can use the PNP, you just need more three resistors for each, two for the divider and one pull down.

      if switching to NPN is simpler then go for it, but PNP will work

    • Grudairian

      14 Volts?
      Duet Hardware and wiring • powerloss voltage • • Grudairian

      14
      0
      Votes
      14
      Posts
      905
      Views

      dc42

      @grudairian, increasing voltage from 12V to 14V will increase heater power by 36%. So definitely worth trying if bed heating is too slow. Remember to re-run heater tuning on both hot end and bed.

    • VJ

      fans on different voltages
      Duet Hardware and wiring • fans voltage • • VJ

      20
      0
      Votes
      20
      Posts
      1722
      Views

      bberger

      Sorry for reopening this again - however with the Revo Micro and it's 5V heatsink fan coming up - is that 5V fan okay to use with the provided buck converter from the HF output on the Smart Effector?

      Skimming through this thread again - I'd say no - correct?

      What are my options?
      (apart from finding a (probably impossible to source) 12V/24V 20x20 fan with enough CFM and pressure..)

      Do I need to run the full length of 1m wire directly to my Duet Wifi?

      May we get lucky and just stick a standard V6 30mm duct with a 30mm fan on it..?