Random Smart Effector flashes

dc42

@sankafola said in Random Smart Effector flashes:

@dc42 i tried that and no flashing , i just did now auto delta calibration and went fine

I presume you mean that when the effector is connected to 5V or 3.3V only, the random flashing ceases. That suggests that the problem is either mechanical interference (i.e. vibration - which is why I asked if turning the motors off made a difference) or electrical interference (most likely from stray magnetic fields - hence my question about the bed heater).

Do you have an extruder mounted on the effector, or is it a bowden system?

sankafola

@dc42 its flaying extruder with 20 cm tube , the thing is if its the bed electromagnet it should affect it all the time not just random , here is my setup

dc42

Does the random flashing stop when you raise the effector well above the bed?

sankafola

@dc42 no the random can happen also while its home which is very far from the bed

A Former User

the light shown is that led's on/near the effector? does it help to turn lights off?

sankafola

these lights of the smart effector why turn off? you think its related to the random flash ?

A Former User

@sankafola said in Random Smart Effector flashes:

these lights of the smart effector why turn off? you think its related to the random flash ?

was just thinking if they were external leds and you're looking for a source of noise, it'd be worth looking into.

sankafola

its built in LED in the smart effector and i dont think its related because they are on while its working normal too its built that way

sankafola

@dc42 just to be sure the LED which flash random is the same LED which flashes 2 times when it turn on the printer

sankafola

@dc42 what do you think ? do you think the smart effector the card itself have something wrong ?

Phaedrux

We will authorize a warranty replacement on the Smart Effector. It's possible there is an issue with it causing it to be too sensitive. Please contact your vendor and initiate a warranty exchange. Include a link to this thread as authorization.

sankafola

@Phaedrux thank you will do