Ender 5 Plus with dual z calibration
-
i dont see anything wrong in the config.
the difference between the homeall and home x / y is:
home x and y use both motors.
the initial move in homeall uses just 1 motor (corexy diagonal moves is just one motor turning)
so things to check. is the other motor actually still, or does it move.
i think its something mechanical
try reducing the speed and see what happens during the move.
so change
G1 H1 X-325 Y-355 F1800 ; move quickly to X or Y endstop and stop there (first pass)
to
G1 H1 X-325 Y-355 F180 ; move quickly to X or Y endstop and stop there (first pass) -
I can tell you the y motor rotates very slowly when performing home all.
I will lower the feedrate tomorrow and report back. Thanks for the help
-
@nightmare90gt said in Ender 5 Plus with dual z calibration:
I can tell you the y motor rotates very slowly when performing home all.
so that could be a wiring problem, a loose grubscrew, or the motor is not getting enough current.
-
Swapped y motor to x driver and x motor to y driver and the stuttering went to the x motor.
-
@nightmare90gt
did you change the wire to a new one? -
No just moved the connector
-
@Veti moved the connector on the duet not the motors
-
try a different wire. it could be a phase not making a connection.
-
Wouldnt moving the connector at the board take the wiring out of the equation? I'm thinking that the y driver might be bad. Because the same motor and wiring on the x driver worked as intended.
-
ah i get you. you did swap the wire that way as well.
so if you move reconfigure the driver to be on the duex it works for both?
-
I dont know how to reconfigure the y driver to be on the duex
-
Changed what it think it would to drive 6 and still get the stuttering
-
Tried reloading firmware, new configuration from the config tool nothing has worked
-
@nightmare90gt said in Ender 5 Plus with dual z calibration:
M584 X0 Y1 Z2:5 E3:4 ; configure 2 Z motors connected to outputs Z and P5
change to
M584 X0 Y6 Z2:5 E3:4 ; configure 2 Z motors connected to outputs Z and P5 -
I did that still did the samething
-
with the motors powered can you move the belt of the x or y motors without much force?
-
@Veti with the printer on I can move the belts without much force. I have even tried this with a spare motor that way belts dont come into play
-
Seems to only do it when x and y are asked to work together
-
maybe the movement wasnt 45 degrees.
after homing. issue
G0 X0 Y0
then
G0 X100 Y100
that should be a movement where only one motor moves.
with the printer on I can move the belts without much force.
not printer on. motors powered. test this directly after a move.
-
Top belt needs a lot of force. Bottom very little
