Update CR-10+Duet wifi from 2.05.1 to 3.0 firmware

Hélder Rocha

@Phaedrux rien de rien... no luck

Hélder Rocha

shouldn t be th fact that i upload from the RRF diffrent IP and gateway?

Phaedrux

Well you can try.

When connected with usb terminal send the commands to set an IP address.

M552 P192.168.1.190

But you'll need to be sure to pick an IP address that isn't already in use. Ping it first to check.

Hélder Rocha

@Phaedrux i beleave there is a misscomunication here, sorry... inglish is not my mother language!

what im trying to say is that, after i upload the new firmware, i used the RRF config tool to give the right parameters to my duet.
In the end, i left the ip, the gateway and the subnet mask as they were there by defaul, and I thought those were the correct ones. But they were not.
So, i beleave i sent to the config of the board, different ip etc etc, and now it doesnt connect.
Could it be right? If it is, do you know any way to solve this?

Using your last suggestion....please,, can you tell me what is the M Commando i should use to set a new IP adress?

Phaedrux

@Phaedrux said in Update CR-10+Duet wifi from 2.05.1 to 3.0 firmware:

M552 P192.168.1.190

This sets the IP address.

You can edit the config.g and enter that or you can test it first over USB terminal.

; Network
M550 "CR-10"
M552 S1 ; enable network
M586 P0 S0 ; disable HTTP
M586 P1 S0 ; disable FTP
M586 P2 S0 ; disable Telnet

Change that section to be
; Network
M550 "CR-10"
M552 S1 P192.168.1.190 ; enable network
M553 P255.255.255.0 ; set netmask
M554 P192.168.1.1 ; set gateway
M586 P0 S0 ; disable HTTP
M586 P1 S0 ; disable FTP
M586 P2 S0 ; disable Telnet

The commands are described here: https://duet3d.dozuki.com/Wiki/Gcode?revisionid=HEAD#Section_M552_Set_IP_address_enable_disable_network_interface

Hélder Rocha

now i having problems on yat... doesn give any access to any port!

Hélder Rocha

Hélder Rocha

is there a way to reset all things and start over?

Stephen6309

@Hélder-Rocha Try running YAT in adminstrator mode. Right click and select Run as adminstrator.

Hélder Rocha

@Stephen6309 the same appens... as i turn it on, it runs all the terminals avaiable and at the end, shows me the same message!

"YAT - [[Terminal21]-COM 5-Closed]

Hélder Rocha

Most problems are solved, but now i have this on YAT:

Warning: IP 192.168.1.2 requested file 'R/A3EKIDA4MTg1NDgxYm...' from HTTP server, possibly a virus attack

Phaedrux

@Hélder-Rocha said in Update CR-10+Duet wifi from 2.05.1 to 3.0 firmware:

Warning: IP 192.168.1.2 requested file 'R/A3EKIDA4MTg1NDgxYm...' from HTTP server, possibly a virus attack

https://forum.duet3d.com/topic/18054/virus-warning-message?_=1612110244839

See here.