BlTouch Issues

[jay_s_uk]

@peirof did you upgrade to 3.4RC1? if so, this is a known issue.
use the build from here https://forum.duet3d.com/topic/27139/rrf-3-4-0beta7-5-sbc-servo-only-responding-once-after-reset/10?_=1644995776018

[peirof]

@jay_s_uk in this moments, not sure, but i think remenber i have 3.4.0 Beta XX??? i check after

[jay_s_uk]

@peirof there was an issue with beta 7 too

[peirof]

@jay_s_uk no... the lottery didn't win me, no... but this... let's hope it's this, it was driving me crazy

[peirof]

@peirof

In the post you have linked... direct to Drobox folder...

Firmware Duet v3 Mini 3.4 BlTouch

this is supposed to be the firmware, with which I have to update my Duet 3 Mini... but I have two doubts:

A- It is not in the usual format. Correct?
B- It is updated in the same way. With the DWC?

[jay_s_uk]

@peirof use the .uf2 and yes through DWC

[peirof]

@jay_s_uk
Tomorrow more..., but dont works after apply firmware...
Panel Due... only works in Io0?

[droftarts]

@peirof See https://docs.duet3d.com/User_manual/Connecting_hardware/Z_probe_connecting#wiring-the-bltouch

For Duet 3 Mini 5+, use IO_1, IO_2 or IO_3.

Don't use IO_4 (okay for MB6HC, but not for Mini 5+), use one of the above. It's because of pin capability, only IO_1, IO_2 and IO_3 are PWM capable. See https://docs.duet3d.com/Duet3D_hardware/Duet_3_family/Duet_3_Mini_5+_Hardware_Overview#io-port-pin-capabilities

Ian

[peirof]

@droftarts mmm...

The tests that I was going to do tomorrow, were in that sense, try other shockets ...

Thanks for the conformation...

Bltouch, does it work with the latest Firmware release?

[Phaedrux]

@peirof said in BlTouch Issues:

Bltouch, does it work with the latest Firmware release?

Yes

[peirof]

@droftarts solved, now works ok...!!! I have connected to io1.

Thanks