Head Offset Problem
I have a problem since I can not understand.
Since a long time ago when I do a Home, my head is in the center of the plateau in a high position.
When I press the Z-axis movement button to lower the head to the tray, it finds it shift about 25mm.
I tried to shift the head using the X and Y motion commands and then run the command G92 X0 Y0 and then make M500 but it does not. Do you have an idea of the problem.
My printer is a TEVO little monster "delta"
deckingman last edited by deckingman
@synergy41 Impossible to say without more information - i.e. your configuration and homing files, which Duet board you have, the firmware version etc etc https://forum.duet3d.com/topic/5909/guide-for-posting-requests-for-help/11
Edit. I've just noticed that the firmware and so forth is listed in you signature but the config and homing files are still required.
Sorry I put you the files of my SD card
Does anyone have an idea of my problem?
Veti last edited by
in your config
G31 X0 Y25 Z36.693 P500 ; Set the zprobe height and threshold (put your own values here) 2.036 , 2.176 ,2.276
from your overwrite i dont think you have run a delta calibration
Dougal1957 last edited by
Suspect that might be because he hasn't got a Z Probe (or at least he doesn't have one defined)
I think my Z "Bl touch" probe is well defined
In my config.g file "M558 P9 H15 F100 T2000"
AndreS last edited by
Put the following at the end of your bed.g:
G1 X0 Y0
and check the result.