@ngwpower Thank you! Yeah i tried that a little bit ago to see if i could skip the web control but unfortunately no dice

@dc42 It worked! I'm finally in! Thank you.

I looked around on the wiki and couldn't seem to find one.

I am fairly certain the end stops are consistent yes. I wonder if there is something involving the belts or maybe the motors causing this inconsistency.

@dc42 no z probe and i am mainly adjusting the rostock's height parameter:

I'm running a duet on a seemecnc Rostock Max V2 and I have been having trouble with the height. Every time I change the parameter it seems to move the head inconsistently. For example, If the height is 2mm to much, so I take off 2mm, I will bring it to the bed again and it will be 1mm too little. It seems to not be consistent in its movement.

Having some trouble with the hotbed overheating. After various heater tunings and parameter updates I have had no success. The main issue is when I set the target temperature for the bed it will reach and then exceed that temperature, triggering the fail safe. Here is my current parameters:

@dc42 That is correct it is un-geared. Thanks for the advice. Ill start messing around with the number.

@stephen6309 as Phaedrux said I don't have the nozzle on that's what I meant when I said "not feeding into the hotend, just out if the end of the open tube"

For reference I am using a bowden tube set up and while testing this I was not feeding into the hotend, just out if the end of the open tube. I told it to extrude 50mm at 5mm/sec. Instead it extruded around 350mm.

And? Sorry I don't follow what you are saying

I have found that my extruder is WAY over extruding. It pushed out a little over 14 inches of filament when instructed to push out 50mm. Seems its over extruding about 7 times too much. I believe this is the parameter I need to change however I am unsure about the formatting of it. Is it a set up as E(steps):(mm)?