@gixxerfast & @fcwilt
yes. -5
@Gixxerfast
checked the Endstopcontroller, rewired it. now it works fine
@gixxerfast & @fcwilt
yes. -5
@Gixxerfast
checked the Endstopcontroller, rewired it. now it works fine
I build my Voron upside down on purpose. After my multitool Tevo Tarantula I decided to get a Printer wich is open on the bottom side to stand on a plate to laser, to plot or to mill. The limits on a moving buildplate were quite hard. So I was constructing and searching for an aceptable design the last 2 years.
Using the Tarantula as a testbed for most of my desired features i discovered the Voron as a near perfect base for my Printer #3.
Features:
Duet3
huge buildspace
multicolor
fast changeable tools
bottomless build
huge removeable filament storage
filament buffer
Some pictures will follow the next days.
@t3p3tony
great jo. Thanks. Works. also with X & Y on 1.0 & 1.1
Also my teststepper died. it doesnt work on the extension nor on the mainboard.
@o_lampe
i used a similar one (7to1) over a year without any problems on it. Transparent is just to see if its feeding the correct path
@mrehorstdmd said in Upside Down Voron:
@cando415 Wow! It looks cool! Does it work? How do you get under there to load filament?
yes. it works.
@mrehorstdmd
its inpired by the shipping containers. You can take away the Voron and get access from the top. or use the rremovable pannels on feont back and side of the Filamentbay.
The spools sin on 4 individual rollers, so its aesy to adjust them to the needes width. set a spool next to them. move them so the spoot touches all and place the spool on top
some updates
10to1 filament collector arrived
spool holder inside filamentpark mounted
coming up next: preextruder wiring
I build my Voron upside down on purpose. After my multitool Tevo Tarantula I decided to get a Printer wich is open on the bottom side to stand on a plate to laser, to plot or to mill. The limits on a moving buildplate were quite hard. So I was constructing and searching for an aceptable design the last 2 years.
Using the Tarantula as a testbed for most of my desired features i discovered the Voron as a near perfect base for my Printer #3.
Features:
Duet3
huge buildspace
multicolor
fast changeable tools
bottomless build
huge removeable filament storage
filament buffer
Some pictures will follow the next days.
@phaedrux great idea. Forgot it totally ️
@matej1006 so the temperature is not the problem
@nurgelrot @fcwilt
The loom is about 3m long including 3 Stepperwires.
rerouting is impossible on this printer.
I try to cut the power, if not needed, of the BLT instead.
@matej1006
tyr the mapping cold and compare with a hot mapping. I think the differences are a problem of the magnethight
@matej1006
Do you use a magnetic bed?
I have the same problems with a 355x355 bed.