@phaedrux
Thanks for help me.
After changing door of the router and reboot... start to work again.
I don't know what happen.. but works ok now.

Thanks

Hello..
Try to search but found nothing..
For some time i didn't use the printer (2 months +/-)
This night try to connect but no luck..
Try to connect with the pc and nothing..
But by phone i can... i uploaded to the last version: 3.4.1rc1.
Ok no error..
By phone i acess the printer, but using the pc nop...
The IP is the same...

Can only acess by wireless..

help me if.. possible..
please..

Hello again....

After instaling with now issue the last version of firmware and the DWC
i have this showing:

The temperature of MCU is around 48ºC and when i put the mouse on top only shows maximum of 28ºC ...

Not normal... I think...

Regards

Thank you.

Yes.
No problem with DWC 2.1.5

With version 2.1.6

M558
Z Probe 0: type 0, dive height 5.0mm, probe speed 50mm/min, travel speed 6000mm/min, recovery time 2.00 sec, heaters normal, max taps 1, max diff 0.08

version 2.1.5
m558
Z Probe 0: type 0, dive height 5.0mm, probe speed 50mm/min, travel speed 6000mm/min, recovery time 2.00 sec, heaters normal, max taps 1, max diff 0.08

The problem is that the numbers disappear in the bar...

Hello... Again..

After updating to the last version of Firmware and DWC when homing the Z i have this:

I update the Maestro bin file, then the DWC zip folder
No error appears..

Regards

After almost 1h of use no problem with the network...

RepRapFirmware for Duet 2 Maestro 3.01-RC11 (2020-04-30b3)
Duet Web Control 2.1.6

Thanks.

@dc42 ok.
Thanks.
Going to try when get home.

Good morning....

After installing the previus version....

FIRMWARE_NAME:
RepRapFirmware for Duet 2 Maestro
FIRMWARE_VERSION: 3.01-RC9 ELECTRONICS:
Duet Maestro 1.0 FIRMWARE_DATE: 2020-04-21b1

=== Network ===
Slowest loop: 104.72ms; fastest: 0.02ms
Responder states: HTTP(0) HTTP(0) HTTP(0) HTTP(0) FTP(0) Telnet(0)
HTTP sessions: 1 of 8
Interface state active, link 100Mbps full duplex

No issue with network connection....