@ccs86 I'm using a CAT7 cable but it not working...I don't know how to fix the problem.

@dc42 said in Accelerometer Usage:

@ducati87 I mean connect the resistor between the SDO pin of the accelerometer board and the wire that goes to MISO on the Duet, instead of connecting the wire directly to the SDO pin.

in spite of the 1K resistor, the accelerometer is not found. I checked the cable on my duet daughter board and everything seems to be ok. Any suggest? Thank you.

@dc42 perfect thank you!

@dc42 what do you mean for "in series with SDO at the accelerometer end of the cable"?

@siam Thank you Slam, I will try it

I'm having an issue with the connection. I used a CAT7 ethernet cable but nothing works. Every time I try to launch the command, the accelerator is not found. Any suggest about which cable I should use? Thankt you.

@phaedrux said in Bad mesh compensation:

It's always best to have the probe as close to the nozzle as possible.

ok I will try to move the probe in a better position. thank you so much.

@phaedrux
is there any chance to fix it?

maybe I should to move the probe in a better position.

@phaedrux said in Bad mesh compensation:

No i mean manually leveling the bed to try and eliminate as much tilt as possible.

No I'm not. Yes but why there is this problem with automatic leveling?

@phaedrux said in Bad mesh compensation:

Have you leveled the bed manually to get it more or less even to the nozzle tip first?

do you mean the z offset?