I lowered my homing speed from 1800 to 1200 and that seemed to quiet down considerably. Perhaps some speed values cause some harmonics.
Latest posts made by bLiTzJoN
-
RE: Microstep Settings for High Resolution Stepper Motors
-
Microstep Settings for High Resolution Stepper Motors
I picked up some .45 deg steppers for a delta printer upgrade. All seems to be fine keeping at 1/16 with interpolation enabled:
M350 X16 Y16 Z16 E16 I1; M92 X320.00 Y320.00 Z320.00 E410.00;
I'm wondering if I should consider changing my settings, or even disabling interpolation given the resolution. Thoughts? They are a bit noisy when homing. I'm still calibrating and haven't tried printing anything yet.
-
RE: Precision Piezo Orion: Errors when probing
So, my issue was the top mount I designed was too rigid causing noise. I've since modified the design and have it working on two of my machines now. Here's the writeup: https://www.thingiverse.com/thing:3192818
-
RE: Precision Piezo Orion: Errors when probing
@peirof, what machine are you using?
-
RE: Precision Piezo Orion: Errors when probing
@moriquendi I started with 2.02RC3, downgraded to 2.01 and then returned back to 2.02RC3 as it didn't seem to matter.
-
RE: Precision Piezo Orion: Errors when probing
This is a new install.
I've messed with the settings for several hours and the best I can come up with is using the following settings:
M558 P5 I1 R1 F380 X0 Y0 Z0 H2 ;
G31 X0 Y0 Z-0.05 P100 ;
Unfortunately, the reading is very inconsistent and on some points will either not move or slams into the bed. I have a video but can't post it (spam). -
RE: Precision Piezo Orion: Errors when probing
To make sure it wasn't the Orion board, I swapped it out with another and still experience the same results.
-
Precision Piezo Orion: Errors when probing
Using 2.02RC3 (and 2.01) on a DuetWifi equipped Delta; I can't get a reading when I auto-calib - every point errors and I can see the effector flexing. It's wired to the zprobe connector. I adjusted the sensitivity accordingly. Set the right z-height (using a manual method). When I tap the hotend I can see the P0 turn to P1000 which to me means it's registering on the board, but not sure why it's not seeing the tap when it probes. In the config.g I have the following:
M558 P8 I1 H2 A2 R0.6 F300 T6000
G31 X0 Y0 Z-0.1 P100 -
RE: Unretraction issues
I do not have that checked and, you're right, it does not use G10/G11.
-
RE: Unretraction issues
I'm using S3D, so I'll have to research what is really happening. I don't believe it is using firmware retraction because I can adjust it in S3D and impact the output. If I lower the retraction to nothing or close to nothing but it does ok. I'm almost finished putting together my 3rd Tevo LM and will start with the E3D stepper that way I will have a printer with all 3 options (Amazon, Stock & E3D) to play with.