Topics created by GiusepRap

@Phaedrux thanks 😅 I deleted for rewriting better but I couldn’t. Thanks, now I try ti update the firmware and After I check it again. Regards Giuseppe

@giuseprap said in Z AXES DOUBLE SETUP:

M584 X0.0 Y0.0 Z0.2:0.4 E0.3
"for selecting the 2 and 3 driver for the z axes".
M574 Z1 S1 P"io3.in"
"for selecting the microswitch z for the two motors"

You have used output zero twice, I suspect Y should be 0.1

For two motors with separate limits, you need two inputs?
This is what I have (on a Duet 6HC):

M574 Z1 S1 P"io3.in+io4.in" ; configure active-high endstop for low end on Z via pin io3.in

@t3p3tony thanks

@giuseprap yes

@fcwilt thanks for the help. I'm using the configurator Reprap for the Duet mini 5+, I've found the pin and the variables. Thanks