Topics created by 3d_druck

@3d_druck Hey it might be too late(könnte auch Deutsch ^^)?!?. Have you set the perimeters right? The servos show some weeeeird behaviour if the perimeters arent set right! And the pulsewidth on my machine is 4ms. Everything under 4ms wasnt working at all.
My settings: M569 P5 S0 T4:4:8:0

@3d_druck said in 25v output from any pin ? Other GPIO pins on the board.:

Thank you for the reply.

Is the Fan pin capable of supplying 25v output ?
I tried to search in documentation but could not find any point regarding this.

Yes, when VIN is 25V.

I tried and it did not work.

I got a new TFT panel display same one and the sd card works fine. So i think its the problem with sd card port in the previous panel.

Thanks for the swift response and support!