Topics created by 762x51

I was saying a handful of Duet OEMs might benefit from including your kit with their printers if aimed at average users. I agree you have a great offering for the masses and no doubt it will help get 3d printing adopted into more homes especially since what you bring to the table is optimization and ease of use.

Not knocking the product in anyway, I will probably point friends and family your direction to make it easier for them to get into 3d printing oh and less support calls for me 🙂 🙂 🙂

The components you have outlined comprise the backlight inverter on the TFT panel. I think it's normal for the chip to run warm, but not the other parts.

This has nothing to do with the display being upside down or mirrored. You can adjust the orientation on the Setup page.

EDIT: I just tested my 5" display. The small 6-pin chip does get hot, but not too hot to keep my finger on it.

You said :

If so do you see the Duet an access Point? Yes I see it and I can connect to it via WiFi

When you connect to it, does it display a list of the SSIDs of the wifi networks it can see, and are you able to select the one you want and enter the password for it?

I'm out of the office at present, otherwise I would provide a screenshot of what that list should look like.