@pcr Give me a link to the test

@pcr M572 D0 S0.07 is a more appropriate value, there is no underextrusion at the beginning of the line, but the outer corners of the model are slightly outward. For the perimeter, this value is not ideal.

@pcr I've tried different values. Can't set up.

But I'll try again

@PCR
Flying Bear 5
Long direct
~10 cm

@pcr I can't find the PA value, because the perimeter prints well, and only the beginning of the line with high underextrusion.

@t3p3tony I am a new RRF user. I did not install other versions.

@alexth

M566 P1 vs M572 D0 S0.11 - Incorrect printing occurs at these values.
This is visible after moving to a new part.

@phaedrux

M566 P1 vs M572 D0 S0

@phaedrux
M566 P0 vs M572 D0 S0.11

@phaedrux
M566 P1 vs M572 D0 S0.11