Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order
    1. Home
    2. ardisf
    3. Topics
    • Profile
    • Following 0
    • Followers 0
    • Topics 6
    • Posts 26
    • Best 3
    • Controversial 0
    • Groups 0

    Topics created by ardisf

    • ardisf

      tool 0 was not driven because its heater temperatures
      General Discussion • • ardisf

      4
      0
      Votes
      4
      Posts
      33
      Views

      Phaedrux

      Are you using the M302 command to reduce the required print temp to below 150 in config.g?

      This would need to be set every time you power cycle.

      https://docs.duet3d.com/en/User_manual/Reference/Gcodes#m302-allow-cold-extrudes

    • ardisf

      filament config for pellet extruder
      General Discussion • • ardisf

      4
      0
      Votes
      4
      Posts
      34
      Views

      Phaedrux

      The filament control is entirely optional. It allows you to set up some macros to help automate a load/unload process or to have specific settings for different materials/processes. That can be whatever you need it to be, but it is optional.

    • ardisf

      tuning 2 heaters
      General Discussion • • ardisf

      27
      0
      Votes
      27
      Posts
      97
      Views

      ardisf

      @deckingman @jay_s_uk a few days ago i've tuned my hotend using dual 60W heaters. actually i got "not recommended" tuning value. after that i can heat my hotend without getting any fault, but right now when i heat my hotend it just turn out to fault because temperature not reached. i decide to tuning my hot end again, but it turns out "auto tune cancelled because target temperature was not reached".
      any solution? thanks

    • ardisf

      desoldering regulator 3.3 volt duet 2 wifi
      General Discussion • • ardisf

      2
      0
      Votes
      2
      Posts
      43
      Views

      droftarts

      @ardisf please keep issues to one thread. I also answered this question there. https://forum.duet3d.com/topic/30662/3-3-volts-led-indicator-doesn-t-lit

      If you can’t post to that thread, it’s because you haven’t verified your email.

      Ian

    • ardisf

      3.3 volts LED indicator doesn't lit
      General Discussion • • ardisf

      8
      0
      Votes
      8
      Posts
      116
      Views

      ardisf

      @RogerPodacter thank you

    • ardisf

      wiring 3rd hotend heater
      General Discussion • • ardisf

      6
      0
      Votes
      6
      Posts
      71
      Views

      Phaedrux

      @ardisf It is heater3 on the expansion bus.

      https://docs.duet3d.com/en/Duet3D_hardware/Duet_2_family/DueX2_and_DueX5#pin-names