Best posts made by asimitabi

@jay_s_uk Awesome! Thank you

I dont have the paneldue here but it works now, I took my laptop from home and made it normally via YAT.

Thank you guys for the fast answers!

Regards

@droftarts the H7 should be disabled. The M307 H7 command gives the answer: "Heater 7 is disabled"
Also I have no M501 command in my config.g so there should be no override of the parameters.
In the config.g file I disabled the heater channel after the endstops are defined and before the M558 defines the bltouch as z probe I think this should be fine.

The z probe value is zero when there is a connection and 1000 if there is no connection.

Thank you for your help!

Edit: I just checked all the connections again and the yellow signal cable was not connected properly.
Really sorry for this but again thank you for your fast help!

Okay sorry guys I just found the problem even though I dont know how this could be.

It seems like the grounding point was not strong enough. I measured the VIN and it was only around 2-3V. So I used another ground point and not it works.
The old ground point was directly connected to the ground of the plug that goes into the printer. Now I connected it to the ground coming out of the power supply.

I did not knew that there could be any difference?
I mean the ground point from the plug also goes into the power supply.

But now it works, thank you anyways @jay_s_uk !

@oliof yes the machine has the M2504 stepper motors. I have 1000mA for the z motors and since I changed the driver everything works well