Controversial posts made by baird1fa

@Phaedrux

I will see what I can do about moving some of that stuff out of the starting script and put it in either the start.g or a macro.

I do have Zhop enabled and the layer counts seem to work fine for every other layer, just not the first layer. It goes from layer 0 to layer 8 once it is done the first one. And then it is off by 8 layers for the rest of the print.

@3dML
I have run some test where I stripped out all of the comments, and in the case where there are no comments DWC didn't find any layers. I even did a test where I removed all the comments except for the layer comments and yielded the same result. But I haven't tried only removing the layer comments.

@elmoret I have several legitimate duet boards and choose to support Duet whenever possible. However, when I bought these printers I could tell them to swap out their parts. The software side is still reprap and any issues from the software update I would hope could be resolved here.

It turns out I popped off the wifi antenna cable when I cloned the SD card at some point after I ran the updates. I was able to get things working all on my own which is why I haven’t been back here to respond.

Thank you for your helpful reply.