@Phaedrux I received my replacement board and now everything works properly. Thank you!
Best posts made by beachtec
-
RE: Tool Board error "Assumed Not Present"posted in Using Duet Controllers
-
RE: DWC only shows "retract" after reaching temps...posted in Duet Web Control
@Phaedrux Sorry about the R parameter... not sure about that one, but removed it anyway with no effect. The mappings are correct. The tool boards appear to be functioning correctly.
-
RE: RRF3 and Duet wifi + Duex5posted in General Discussion
I finally got back to the Railcore RRF3x issue and ended up pulling my boards... @Phaedrux mentioned the Duet WiFi was a cloned board... and I think that was the problem. I put in a genuine Duet board I had on hand it is has been working without a hitch. It is POSSIBLE that the very act of the board R&R corrected a wiring issue (intermittent connection) or the like... sometimes it is hard to tell if things are terminated properly. Overall a great learning... nothing gets me from rote knowledge to understanding faster than solving challenging problems - cheers.
p.s. thx to @JoergS5 too for the help!
-
RE: Weird Behavior Duet 3 / RRF 3.2posted in General Discussion
@fcwilt Only 2 extruders in use on this machine.