Seems strange given the case has been on it since day one, but I'll take it out of the case and see if it resolves it.. will report back. thanks

Re: PanelDue beeping? Confused.

My Paneldue has started beeping constantly, the weird thing is that it still registers touches, and the printer still works fine if I operate it from the web interface, I had to unplug the paneldue due to the annoyance of the noise.. and suggestions how I can fix the paneldue to stop it from beeping?

I assume this just means running 2 wires to each of the stepper pins on the duet, are there any concerns with doing this other than current?

8-Wire Stepper Motors

Some motors are also offered in 8-Wire configurations allowing for multiple wiring configurations depending on whether the motor's speed or torque is more important.*

It is possible to connect an 8-wire stepper motor with the windings of each phase connected in parallel as shown in Figure 4. This configuration will enable better high speed operation while requiring more current to produce the rated torque. This connection type is sometimes known as parallel bipolar wiring.
from : https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z000000PAkPSAW

@dc42 thanks, I was hoping this would be the case.

@msquared thanks.. do you know if there is a mobile app that supports it?

Beside Safari

@MSquared I think thats more for PT100 sensors..

Is it possible to enable the mobile API's so that I can use the Discourse app to read and respond on my phone?

@dc42 or anyone else with more experience than me..

Would there be any obvious issues using a PT1000 with a short cable (~10cm) going to a plug/socket just above effector, and then wire back down to the Duet?

Anything special need to be taken into account for the wire used for the run back to the Duet (AWG rating, resistance, etc)?

@T3P3Tony please count me in if there is still room for more testers

Just reporting back that after updating my network gear to Ubiquiti Unifi kit everything is working properly again.