Posts made by briskspirit

No, I meant leave it at Z max and use both. But never mind, thank you! You have answered my question )))

Hi all.

So I have installed my BLtouch and wondering if it is possible to use my old Z max endstop just in case as a fail stop?

Thanks.

@dc42 That card was with Duet and worked fine. New web interface helped to solve this error.

Hi.

After some time I can't upload big .gcode files through web(one file is ~4.5Mb and other is 12Mb) Checked my SD card - everything is ok(original that was with Duet Wifi)

Firmware Name: RepRapFirmware for Duet 2 WiFi/Ethernet
Firmware Electronics: Duet WiFi 1.02 or later
Firmware Version: 2.02(RTOS) (2018-12-24b1)
WiFi Server Version: 1.21
Web Interface Version: 1.22.6

@wyvern Mmm... explain please. Which one are you using now?

@genghisnico13 So slicer's settings will be ignored? For temp and etc. And can you show your files please?

@wyvern This worked:

@r3play bulls eye! Thanks for your idea Redone my cooling fan and now everything is good even at 70mm/s with PETG

@mrehorstdmd good idea!

Have the same problem after upgrade to Duet and still can't solve it yet...

@vwegert I cut that sock to free whole nozzle as it got ripped after 3-4 prints ...

Ideas how to improve? I only have 5mm of clearance to make that fan, so it is so "flat"

@r3play I have made it for turbofan. Maybe you could be right and I need to change it's design...

Printer type: Cartesian (Replicator/FlashForge clone)
DuetWifi 1.04 FW 2.02
Material: PETG, temp 230C, bed 80C first layer, after - 70C
Slicer: Simplify3D 4.1.1
Layer height 0.2mm, 2 outlines, 3/3 bottom/top layers, speed 50-70(tried both), outlines/infill/bridges 71% from main speed.
Print fan ON
Pressure Advance is OFF

Jerk XY 600, accel XY 2000 and 600(tried both)

Everything prints good, good retractions, good bridges and etc but getting the nose of 3Dbenchy like melting... If i try 220C nose will be a bit better but layer adhesion is almost gone. And nose melting do not depend from bed temp.

@bret4 Yeah, I love PETG and hate the mess around nozzle That's why thought about brush

piece of brass? thin enough
brass brush?
I plan to do the same and will use brass brush that is used for guns/rifles cleaning

@alexlin Can you show your accel/jerk/max speed settings and M593? Because I still can't understand what am I doing wrong... still can't get rid of rippling at any frequency...

@dc42 So I need to make some macros and call it from config.g ?

I put every custom setting into config-override.g just for convenience

Will ask again... How should I choose min and max speed for calibration script? Max speed is the overal speed(70mm/s for me) or outline speed? (42mm/s). Min speed correlates with jerk speed or ..? Thanks!