Posts made by brotherchris

@lo-fi Hey man, I just wanted to thank you, new housing is working great!

@lo-fi Super interested in trying your sensor housing when it's complete. I am having the same issues others appear to be having.

@matt3o No, great to hear, I am too working to find ways to improve.

@Veti They are gates high temp belts. That could be the issue. Maybe these are stiffer then regular belts. https://www.printedsolid.com/products/gates-powergrip-2gt-high-temp-belt-1m

@Veti Check this out, top pic, Gates belts. Bottom pic cheap Amazon belt. My only guess if the cheap belt teeth are more forgiving.

@Veti I will take another look, I might have to make some modifications. I don't know if the setup I have now will let me get any closer.

@brotherchris

@Veti No worries on that. It's kind of a mess at the moment, but here are some shots of the stuff that matters.

@Phaedrux Different stepper. I might try the other E driver though.

@sebkritikel I now have a Bondtech BMG and mosquito installed. The artifacts appear to be the same, but I will run another pyramid to see if there are any changes.

@sebkritikel Here are the results of the pyramid. It breaks the strait lines into more of a gradient.

@theruttmeister I misspoke, I meant extrusion width. It's a .4 nozzle, it was just a test to see the impact.

@Phaedrux Never a bad idea.

@mwolter Hey I ran these tests and the flow rate definitely impacts the 45 degree lines. This is a .4 and a .47, huge difference. No luck on the verticals.

@sebkritikel Yes, it seems to happen on all prints. I will print a pyramid and see what it does.

@Phaedrux The max speed test is interesting. Started at lower speeds. As it got faster the ringing increased, the artifact stayed the same.

@bot Most of the bearing are 8mm ID and 16 OD. I have 2 that are 8mm ID 12mm OD, 1 in each path to help with clearance.

@Phaedrux Still confused, the belt flip didn't change anything.

@Veti Nice find, I am going to grab some for testing.

@Phaedrux Run a test with a belt twist now.