Topics created by campeancalin

@campeancalin said in stepper driver for the active toolhead no longer works.:

@dc42 in my config.g file I have set the following:
M584 X0 Y1 Z2 E3:4 ; set drive mapping;
so normally, so will it suffice just to switch the cables from E0 to E1?
Or should I use the M584 as bellow?
M584 E4
And then afterwards M906 E1200 I80?

Yes, send M18 E0:1, swap the cables, then send M584 E4 and then M906 E1200.

@campeancalin said in Resume after power failure question:

Hello, @dc42 thank you but is there a more detailed documentation to it?

No, because the details of what to put in the resurrect-prologue.g file depend a lot on your particular printer. But please ask if there is anything in it that you don't understand.

I had the same problem.
--> worong wiring ?
I switched y and x axis motor cable on the duet board.
Problem solved.
May check this

How many walls are you using? Are you using concentric infill?

It's typical to use only a few walls and solid or rectilinear infill for the rest. Using too many walls can lead to over extrusion building up.

@campeancalin said in G29 failing height map for a core XY config with fixed bed:

@fcwilt Can you share an example of each of the macros you specify? Just so I have an idea where to start from.

Hi,

I would be glad to share them with you BUT my approach is not what you would call a common approach.

You might say it's a bit more "advanced" or maybe just "complicated" because you have tasks coded in different macros. You cannot just look at one file and see every command. You, of course, see the command to invoke the macro (M98 P"some_macro.g") but if you don't remember what the macro does you have to open that file.

It's a bit more work but I do it because I can invoke a given macro from different places and know that it is always going to do the same thing.

For example, I can invoke "map_load.g" from the console, from a DWC macro, from my "print_begin.g" macro and it will always do the same thing AND it will always work, assuming I have written it correctly and tested it to be sure it works.

So if you still want to see my macros just let me know.

Frederick

Thank you again for the info @Veti. Everything works with "duex.pwm5" set up.

No, your Z axis is configured to use the probe.