@cromker said in Print Just stopping and disconnecting from Web Control:
The Super extruders, installed them and they wouldn't work, what I discovered was that the firmware is set up to run PT1000 thermistors with the Super, however, the purchased extruders came with standard E3D thermistors. The manufacturer suggested that because we don't run high temps, just run them using the regular Volcano set-up. Could this be the issue?
I don't think this is the cause of the driver overtemp, if that's what you mean.
As for the PT1000 versus a normal thermistor, that's an easy configuration change to make.
1200mA on an extruder isn't crazy, but on a long running print heat build up may be an issue. To test that theory gathering the info infiniteloop requests would be good. You can also try improving cooling by adding a fan or leaving the enclosure open. Without being able to see it I can't give any more specific recommendations.
