Posts made by danny777

@phaedrux

Thank you very much !!
Did update paneldue firmwere , looks that it work perfect,
THANKS,

Ok, so i will try to udate the paneldue
I did the touch calibration, I think its ok now,

@phaedrux
In the console it looks like I updat! but in config.g it say 3.2.3

The duet firmware version now 3.2.3
paneldue version 1.24

I allready updated the paneldue using bossa when I installed it (few weeks ago)and its run well
I understood that now i need to update the duet 3 board via usb, am I wrong?

Its very comlicated for me to update via USB , is there another way ?
Or maby I can update only the duepanel , and then upload the 3.3 to duet3 via dwc?

with bossa
?

Ohh,
Im trying to udate, via dwc, its uploading the files , but when I press yes for install its say no sistem files

M122
console (1).txt

This one, first tap and secont tap the head go -0.5 then third or four tap the head go up 5mm,

@phaedrux

HI,
Can I we posts together in this thread?

Sent m122 again , attached
console.txt

Now after update firmwere ,I have a new problem, if push z 5 mm up it moves down
and not all the time , once is up and once it down , same button

here

Did it! look better but still "error; invalid use of p parameter"
03ce6d49-eec4-4e3f-a336-bdd208f1043a-image.png

Im not using a raspberry pi
version - Duet Web Control 3.1.1

It looks like lots of details thet i run throough the dwc showes on the console,
for exemple , when I run mesh compensation i get this

Yes I work with the machine ,