Topics created by dbrb2

@jay_s_uk Ah....yes I may simply have my signage inverted....let me try that!
.....goes to try it....

Yes, that was it! How embarrassing! Thanks for the steer though!

@o_lampe so far that is looking good....

I moved from a geared extruder that was relay hard to thread to this one - but didn't increase the current, despite the obvious need to have more torque!

Fingers crossed....

@PaulHew thanks
Mechanically and electrically all now works. Something I suspect though is wrong in my config still. My 20mmcalibration cube gets this far:

cube.jpg

Which doesn't look great, before reliably lifting from the bed entirely. I have set Z quite a few times, and checked the bed temperature. This isn't a problem I had with the old stock board, so I suspect the issue is with my config....perhaps something to do with my extruder settings:

https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+4:+Calibration/40#s165

I'll double check them. Will get there though...try again tomorrow!