Topics created by dieterdd

@dieterdd said in My 3d touch risks leg breakage🧐!:

Since I build a large printer (100x50x50 ) I have very long cable runs (from the duet3hc6 to the print head ca.3.5 meters) there is a "cable sandwich" difficult to realize.

One of my first printers had long wires to the extruder since I used cable chain on both the X and Y axis.

I don't do that anymore. I now use Zesty Nimble remote drive extruders which have the flexible "drive shaft" running from the frame to the extruder (under a meter). I use that to carry the wiring.

You can do something similar using spring steel strips or rods from the frame to the extruder and use that to carry the wiring. The E3D motion system uses this approach.

(Hey Frederick, I also have a Hobie Tandem Island 🙂 )

The two person version?

Now it works. 😀
I was confused at first, however, that the nozzle does not move to zero when referencing, but only when you give the command to "drill" 🙃 into the bed, then it stops dutifully at 0.
Danke! Thank you!

@phaedrux
Never think to have thought, because thinking the thoughts (I would have used a 24V heater) is thoughtless thinking ... it was a 12v heater cartridge😬🙃🙂 thank you! danke!

@phaedrux All axes do what they should

I had probably used too inflexible cable, because after I had replaced the white by a remaining blue in the cable channel was then the red broken. So I had to make the complete cable chain "empty", and replaced all cables of this type😑 . But now it works.😀

Thanks for all your help.

Now comes the installation con extruder and honend .... there I will soon probably put another call for help in the forum ... but first I will try to understand the existing Gcode.
Thanks and see you soon.🙂

That looks right. Let us know if you need a hand with configuration.

https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_BLTouch

Works, the exclamation marks have brought the solution. also for the naming of the cables, that brings self-confidence in doing...

Until the next question mark what wants to put me in the way.
🙁🙃😃😉
Thanks!
Dieter