@zapta
Is there an alternative for the ACS70331EOLCTR-2P5B3 that can be used? They are not really available at the moment and if only extremely overpriced
Best posts made by Dogma2k
-
RE: Anybody wants a stepper motor analyzer?posted in General Discussion
-
RE: [3.4.0b7+7] Heater overshoot if second K value in M307 is usedposted in Beta Firmware
I have the same problem since 3.4.0beta7+7 and 3.4.0RC1.
Whenever the fan speed changes, the algorithm doesn't seem to take it into account. I always print my bridges very slowly and therefore reduce my fan speed slightly during this time, the target temperature is always overridden by approx. 5 Kelvin to the target value, even if the change is very short (e.g. 3mm bridge). -
RE: Anybody wants a stepper motor analyzer?posted in General Discussion
So that the prototype housing of the AWD Stepper Motor Analyzer fits quite well, just adjust a few small things.
-
RE: Anybody wants a stepper motor analyzer?posted in General Discussion
@zapta
Unfortunately only provisionally because I don't have my 5V transformer an Arduino Uno yet
-
RE: Anybody wants a stepper motor analyzer?posted in General Discussion
The final case is finally ready. I also installed a FlowMeter. Everything fits in and the lid even closes.
If you like, you can download the STEP file
-
RE: big problems with print bed and meshposted in General Discussion
@phaedrux
Thanks for the 1st layer test, it worked wonderfully.