Topics created by eduardschlegel

@eduardschlegel said in right motor for a cnc:

one last question, can I drive the two x-axis motors over the Z1 and Z2 connector

Yes. However, that will "split" the current between the motors, or, if you prefer "double load" the driver chip.

MUCH better to put them on separate drivers, and configure those as one axis in duet (like X3:4).

@Nuramori said in New setup after errase and wifi antenna switch:

There's clearly a missing SMD at the upper left corner of the SD card holder, R73

There are DNP components (including R73) on the board. See the schematic:
https://github.com/T3P3/Duet/blob/master/Duet2/Duet2v1.04/Duet2_1.04c_Schematic.pdf