Topics created by Fizban

Ok so I came across the M540 and found the mac. Forced it to 112 in router and now it is working. However!
It's still not showing on the mac list having access to the router. What gives ?

@fizban said in Finally got the BLtouch working on the Maestro!:

Sorry I can actually see now that I just read across it. The M280 line is clearly stated above the Meastro section, it just wasn't bling enough for my eyes to catch it. you have specified adding P64 removing I3 I apologize!

You might have read that page before I updated that part a few days ago. I wrote it in response to a post on these forums, possibly yours!

@Duckle Makes sense, before upgrade it was ninja silent, now it resonates a wee bit.
Gotta say I thought my 8825 was quiet, but this is wonderful. I do however miss not being able to hear if it actually runs 😛

Anyways first test print of the cube was good.

Think I need to tune my PID, get the BLtouch sorted and fully calibrate the extruder it's off by +.07mm on the cube, and figure out some non duet stuff like why I still get vertical bands after upgrading to linear rails.

I will undoubtfully return with more questions later haha.

Ok so I've got it all connected.
Board runs 24v powering system/bed/steppers
hotend runs 12v via the old mosfet.

Blowers runs on the 5v and the heatsink fan is directly powered by the 12v psu.

Now to make another post, cause I cant connect to the damn thing 😞

Thanks for the help regarding this!

@snowcrash Oh I know, but it's lasted a while now on the raspi. Its rated for 10A/250v so 2000w would be plenty safe 🙂

I'll start by hooking up the board and run a test print.
I'm not at all familiar with RRF so it's a new world. After that I'll get the relay sorted.