@Furbyhaxx 8 factor calibration did not work..
Latest posts made by Furbyhaxx
Strange bed distortion on delta machine
Hi folks. I have a long lasting problem with my delta machine (TEVO Little Monster).
I use the nozzle as probe (24v to nozzle, GND to aluminium bed)and custom magball arms.
Auto bed leveling gives me this S-curve warped bed but it actually is flat min max is -0.2/+0.6mm according to auto leveling.
What could cause this? I don't know any further..
Filament gcodes M701,702,703 crashes board
Today I discovered that every filament related gcode crashes the board immediatly without additional infos (also not in the log)
M115 FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 3.2-beta2 ELECTRONICS: Duet WiFi 1.02 or later + DueX5 FIRMWARE_DATE: 2020-10-05b2
This happen if I issue the commands directly or over the DWC functions. Also with an emtpy filament.
RE: PanelDue Stopped working
found the error trought RRF, this line was missing from my config:
M575 P1 S1 B57600 ; enable support for PanelDue
interesting is that another machine with the same config and firmware 3.0 also not had this line but the PanelDuet worked without problems after updating.
PanelDue Stopped working
Today on one of our printers the PanelDue stopped communicating with the DuetWifi while updating to firmware 3.1.0. I Tested 3 LCD incl. boards and two 4 pin cables but the PanelDuet stays at "connecting".
When I update the Duet firmware over DWC the PanelDue shows the messages from the firmware update.
Ah, PanelDue firmware was also updated to v1.24
resume.g not executed
If i pause the print (over DWC or PanelDue) and restart the file resume.g is not executed.
What can cause this?
Board: Duet WiFi 1.02 or later + DueX2
Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.0 (2020-01-03b3)
Version von Duet WiFi Server: 1.23
RE: Optical endstop problem and multiple Z motors
thanks, when I mesaure across GND and Z PROBE IN I get constant 3.2v, when probe is not triggered and around 17v with a 10k resistor. without the endstop connected I also read 3.2 between GND and Z PROBE IN, is there something defective?
Optical endstop problem and multiple Z motors
Hi, I'm retrofiting some big core xy printers with duet 1.04.
They have three big Z motors and an optical endstop on each to level the gantry because the bed of 800x800 is fixed.
Q1: the optical endstop connected to Z probe runs on 24v, I read 24v when triggered and around 1.5v when not triggered. So the duet always sees a triggered state. Do I need to connect a restor to ground or on the signal pin?
Q2: is it possible to assign each endstop to the corresponding motor so we can level the gantry or is a z probe on the head the only way?
Thanks in advance