@Phaedrux , @dc42

So there is progress .
After the third installation of paneldue software finally I have thumbnails .
But the strange thing is that I had to install the version with the logo , and only appeared thumbnails later after returning to the software without the logo that was originally still there . From my point of view , flash cleaning does not work or causes problems and some garbage remains. I once had a similar problem with ESP8266 and had to upload Blank.bin to erase the flash.

And now the question is do you have plans to add a thumbnail display on the Status panel when printing?

Greetings ...

Ok
Thanks . I'll fight with these "Chinese" I don't need such an extended expansion board and the more so at my place you can't get Duex2 anymore.
Greetings.

Fail . Y0.2 and Z0.2

M584 X0.0 Y0.1:O.2 Z0.2 E0.3 ; set drive mapping

E P1.0 ?? no E0.3 ?

M569 P1.0 S1 ; physical drive 1.0 goes forwards

@Phaedrux , @dc42

So there is progress .
After the third installation of paneldue software finally I have thumbnails .
But the strange thing is that I had to install the version with the logo , and only appeared thumbnails later after returning to the software without the logo that was originally still there . From my point of view , flash cleaning does not work or causes problems and some garbage remains. I once had a similar problem with ESP8266 and had to upload Blank.bin to erase the flash.

And now the question is do you have plans to add a thumbnail display on the Status panel when printing?

Greetings ...

@dc42
Yes .
I know How and when the thumbnails should be displayed . But with me it does not show them.
Tomorrow as suggested by @Phaedrux I will upload paneldue firmware again .

@Phaedrux

PanelDue-v3-7.0.bin
Installed 18.02.2023 final version 3.41 without Logo

As in the title .
How to get the gcode thumbnail display when printing on Paneldue ?
Paneldue software version 3.4.1
Duet 2 Wifi beta version v3.5 2.
PrusaSlicer 2.5.1 in settings : Reprapfirmware , QOI, 120x120.
Cura with plugin : Cura-DuetRRFPlugin.
In DWC thumbnails generate correctly but on Paneldue nothing.
What am I doing wrong ?

Ok
Thanks . I'll fight with these "Chinese" I don't need such an extended expansion board and the more so at my place you can't get Duex2 anymore.
Greetings.

@jay_s_uk said in Duet 2 and additional drives.:

2209

And are there any plans to add support for 2209 ? It would be great to be able to expand on original components and not "Chinese".

Hello,
will Duet 3 Expansion Mini 2+ work with Duet 2 WiFi? I need to add two drives and this board is quite affordable.

Finally it worked.
I found the solution here: https://forum.duet3d.com/post/227278
Regards, you can close the thread.

@dc42

OK.
I give up . Maybe I'll come back to the topic when a new version comes out. Maybe someone will be more determined to run it on Eclipse.
For now, I'm staying on version 1.24.1. (This still compiles without errors)
Regards.