Topics created by greeno76

@dc42 Thank you. The math looks good. I will try it out.

In the mean time I used a couple blocks to align the part to the x and y axis and then found zero using the edges of the part. It would be great to have a macro that allows you to place the part/stock and then adjust the machine using the edges without having to do the manual alignment. Assuming you have a couple straight edges perpendicular to each other. Another handy thing would be a macro to flip the part if you need to machine both sides of the part. Is there a G code that allows you to mirror one of the WCS axis?

This might provide a possible solution. https://github.com/rclone/rclone ??

Definitely want to avoid having to reinstall everything again in the event of an SD card failure!

@phaedrux I should clarify in case its misleading for anyone in the future.

The original DuetPi image was downloaded from the official GitHub location as was the last install which appeared to solve my problem.

I think I must have bodged the HDMI screen installation tbh. I ran some install command but really it just needed to be configured in config.txt.

All seems to be working now. I've since upgraded to the 3.4 RC and I've successfully tested motion on the stepper motors.

Thanks again.

Jason