In case someone comes to this issue also (even when the thread is already some months old).

I had exactly the same behaviour that was driving me crazy. It took a while to recognize that the PWM 5V+ Aux needs a jumper to be set.

It should default to use internal 5V. But on my Duex5 board there was no jumper set. For that reason the PWM5 port did not get 5V+.

I marked it green on the following image.

I hope this can help some users to get rid of that source of problems.

Credits: Original image from here: https://duet3d.dozuki.com/Wiki/Duex_wiring_diagrams

Hi everybody,

is that solution able to do both? Stream a video to the DUET3D web front end to check if the print is still working as expected AND creating time lapse (time based or on layer change) at the same print in parallel?

Or is it only for making time lapse?

My plan ist to get a raspberry pi (3, 4 or zero) in combination with a logitech HD920 cam.

When I had this error message it was a broken cable (one of the 4 cables to the stepper).

Having it on multiple steppers might be caused by another reason.

In case someone comes to this issue also (even when the thread is already some months old).

I had exactly the same behaviour that was driving me crazy. It took a while to recognize that the PWM 5V+ Aux needs a jumper to be set.

It should default to use internal 5V. But on my Duex5 board there was no jumper set. For that reason the PWM5 port did not get 5V+.

I marked it green on the following image.

I hope this can help some users to get rid of that source of problems.

Credits: Original image from here: https://duet3d.dozuki.com/Wiki/Duex_wiring_diagrams