Best posts made by ICY_SNAKE

@icy_snake Good morning,

i connected all metal cases to ground.
Now it´s gone.

Had to get ride of paint, so that there is an electrical connection.

thx
Dieter

@icy_snake Thx Frederick

i´m from germany Augsburg. You are from the USA, located Verginia? For time offset.
east cost 6 hours i´m ahead.

@fcwilt Whowww, many thanks Frederick,

perfect support, you helped me alot, thanks again.

I´m often in the USA for business. Maybe there will be a day that we could have some drinks.

Best Regards
Dieter

@icy_snake I´m already home today, here it´s evening.

I will add tomorrow the new code. I let you know if i could get it running.

Good evening
Dieter

@fcwilt hahah yes it was and it is and will be in the future.

thx all for the perfect help here.

Dieter

@fcwilt said in Is filament chnage required?:

the filament change message you mentioned in an earlier po

yes we have the macro which gives the message but not sure why it comes up during printing.

As i wrote in an other post that there are problems with statics voltage, do bad design of the printer.

I added ground to all metall pieces, had to get ride of paint etc.

Now i can touch the dispaly or printer without any failures or messages on the display.

my feeling is the reason was the missing grounding.

I´m printig now a big part, total progress 540h . already 96h done.

Thx for your help
Dieter

@jay_s_uk

so here i will set:

 M906 X1800.00 Y1800.00 E560.00:560.00 I40 				; Set motor currents (mA) and motor idle factor in per cent

Ok yes.

Thx
Dieter