Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. jamaicarasta
    3. Topics
    • Profile
    • Following 0
    • Followers 0
    • Topics 6
    • Posts 74
    • Best 5
    • Controversial 0
    • Groups 0

    Topics created by jamaicarasta

    • jamaicarastaundefined

      Input shaping help

      General Discussion
      • • • jamaicarasta
      26
      0
      Votes
      26
      Posts
      1.0k
      Views

      jamaicarastaundefined

      @jay_s_uk Thanks for your help man, now the Test print. That was the Print yesterday without shaper. 100mm/s and 7000accel. Not bad with 7000accel. Voron 350 with lgx lite and carbon x axis and 1 mgn12 rail.
      IMG_3887.JPG

    • jamaicarastaundefined

      First time cura and my problem

      General Discussion
      • • • jamaicarasta
      12
      0
      Votes
      12
      Posts
      369
      Views

      jamaicarastaundefined

      @stephen6309 and my first print with cura was better than superslicer 👌
      I will try it tomorrow with a few prints.
      greetings from germany

    • jamaicarastaundefined

      Bondtech LGX how i tune acceloration and jerk?

      Tuning and tweaking
      • • • jamaicarasta
      3
      0
      Votes
      3
      Posts
      505
      Views

      jamaicarastaundefined

      @daveh hey thanks, the bondtech webside have already found.
      I'll take a look at the other link.

    • jamaicarastaundefined

      Switch from 3.3 to 3.4RC2

      General Discussion
      • • • jamaicarasta
      8
      0
      Votes
      8
      Posts
      326
      Views

      infiniteloopundefined

      @jamaicarasta said in Switch from 3.3 to 3.4RC2:

      I'm interested in whether the config is fresh or my old one.

      Always keep a copy of a version which works, so you can revert to that if some new installations, configuration changes etc. don't run as expected. I understand that you now have a trusted setup with RRF 3.3 - keep a copy of this state before you install 3.4. I even make copies of the SD card before I fiddle around with the config or my macros, not only in the event of a new firmware version.

    • jamaicarastaundefined

      Slicer take the wrong fan

      General Discussion
      • • • jamaicarasta
      26
      0
      Votes
      26
      Posts
      685
      Views

      jumpedwithbothfeetundefined

      @jamaicarasta glad you got it sorted! so its all up and running properly now?

    • jamaicarastaundefined

      Duet3 mini voron gantry level problem

      General Discussion
      • voron2.4 gantry level problem • • jamaicarasta
      46
      0
      Votes
      46
      Posts
      1.7k
      Views

      Phaedruxundefined

      Measure your offsets: https://docs.duet3d.com/en/User_manual/Connecting_hardware/Z_probe_testing

      Alter your grid size to take into consideration the physical offsets. Skipping points it can't reach isn't necessarily a problem, but it does mean you could have a more efficient usage of points. Though if you're not using the maximum 441 points, does it really matter?