@jondaniel yes i agree something is wrong with my original wiring. i just recrimped a new cable and thats what that picture is of. Thanks for the config.
Best posts made by jcwild
-
RE: bltouch on duet maestroposted in Duet Hardware and wiring
-
RE: changing endstop side(min or max)doesnt change homing directionposted in Firmware installation
@fcwilt Got it! changed Y-1
0 to Y 1:1:0 and that did it. so im pretty sure what it corresponds to are the 3 motion motors, normally called x y and z and the 1, -1 and 0 are which direction the stepper motor should turn, 1 for forwards ,-1 for backwards and 0 for none. Thanks for the help -
RE: bltouch on duet maestroposted in Duet Hardware and wiring
OK so i plugged that new harness into the original sensor off this machine and it deploys and retracts with commands!
-
RE: changed one line in config and my duet froze and stopped workingposted in Firmware installation
@phaedrux chrome and Firmware: RepRapFirmware for Duet 2 Maestro 3.3 (2021-06-15) and dwc 3.3.0
-
RE: bltouch on duet maestroposted in Duet Hardware and wiring
@ashillis mines working fine now wired through my connector all mounted up properly. i wasnt welding anything, all crimped connections. no interference. just shoddy connections preciously