BINGO!
I recreated the config from scratch after updating DSF. The probe is deploying and retracting now.
THANK YOU!!!!!!!!!!!!!!!!!!!!!!
Best posts made by jdumoulin
-
RE: BlTouch setup on Duet 3. Probe will not deploy with G30posted in General Discussion
-
RE: Cannot change can address with M952: Command is not supportedposted in Duet Hardware and wiring
Your question pointed me in the right direction and I switched to the unstable feed and did an upgrade. Browser acces is back.
Now a M952 B10 A20 gives me a Warning: M952: Board 10 received unknown msg type 2010
-
RE: Cannot change can address with M952: Command is not supportedposted in Duet Hardware and wiring
OK, figured it out. after this I upgraded the tool board after which its address changed to 121. So now I did a M952 B121 A20 and it changed the addres to 20.
Now m115 b20 responds with:
Board TOOL1LC firmware 3.01-RC11 (2020-04-30b1)Thank you!
Jay