Best posts made by jml

Dave's the best

Yeah you're all right, I would want it synchronized. I guess though that the solution might be more related to the slicing rather than the firmware.

@T3P3Tony No worries, I figured! But I will keep my fingers crossed

My preference is to have it only pop up if I press the up arrow - then I could see the historical entries, and hit enter in order to select one. This is basically how Pronterface/Printrun worked and was extremely helpful for me (but it didn't have a popup window - it just autofilled one entry backwards with each arrow press).

@monster-delta How fast should the image load? I've added the splash screen, but it takes almost 7 secs to load (starts from the bottom and goes up). And it waits for a few seconds before disappearing.

Is it possible to make it load the image faster? Can I adjust how long the splash screen remains presented after it loads? I don't mind messing around with the firmware.

@t3p3tony I thought I wasn't, but then checking the g-code, the slicer referenced the unused extruders (setting them to temperature 0). I removed these lines manually and it seems to have fixed it!

@t3p3tony in case I have mounted a tool imperfectly.

Its looking like a wiring issue... If I send the command once, the probability of the peripheral device reacting is low. But then if I hold the enter key down so that it is sent a hundred times rapidly, then at some point during that time, the peripheral acts as if it has received the message. These damn cheap jumper wires!