Thanks for the replys!
Here's a quick video on how it behaves while printing: https://imgur.com/a/Kao8khP
The MOSFET sounds like an great idea. I have an MKS Mosfet laying around.
So i guess this will move the load to the PSU rather than the Duet2Wifi.
How many AMPs will the Due2Wifi have while connected to a mosfet with the 12V 220W bed?
I've got an Duet2Wifi i'd like to upgrade my old CR-10 mini with. The CR-10 has a bit unusual heated bed (305*235) and is 12V at 220W = 18,3 A.
Since this bed is uncommon size it's hard to find any 24V alternatives. I also prefer not to have an AC bed on this bedslinger.
On https://duet3d.dozuki.com/Wiki/Choosing_a_bed_heater it clearly states: "Direct from the Duet using 12V power. The Duet 2 (Wifi and Ethernet) is rated for up to 18A bed heater current, so this is suitable up to 12 * 18 = 216W power."
Could it handle the 18.3A on my CR-10 mini? If so i'd also need to replace the 15A Miniblade to a 20A, right?
I have a LED-strip connected to one of the FAN-pins on my Duex5 and on boot it blinks the LED's due to fan blip.
I've tried using the B0 command;
M106 P3 B0 S1 H-1
But it doesn't seem to work. I'm using v 3.1 of the firmware.
Is there a fix for this?
I've just noticed that my Duex5 is no longer showing up under Settings -> Machine-Specifics and "Electronics".
Board: Duet 2 WiFi (2WiFi)
Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.1.1 (2020-05-19b2)
Duet WiFi Server Version: 1.23
And if i run "Diagnostic" it recognises the duex;
=== Diagnostics ===
RepRapFirmware for Duet 2 WiFi/Ethernet version 3.1.1 running on Duet WiFi 1.02 or later + DueX5
Can anybody with a Duet2Wifi + Duex and Duet Web Control 3.1.1 check their?