Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. Kiwi 0
    • Profile
    • Following 0
    • Followers 0
    • Topics 3
    • Posts 6
    • Best 0
    • Controversial 0
    • Groups 0

    Kiwi 0

    @Kiwi 0

    0
    Reputation
    1
    Profile views
    6
    Posts
    0
    Followers
    0
    Following
    Joined Last Online

    Kiwi 0 Unfollow Follow

    Latest posts made by Kiwi 0

    • RE: Saving M208 to config-override.g

      @droftarts
      Thanks for the hint with the H3
      It was in the toolchange macro and probably a heatertuning with a M500 at the end brought it do the override...

      Thanks a lot!

      posted in Using Duet Controllers
      Kiwi 0undefined
      Kiwi 0
    • Saving M208 to config-override.g

      Re: Saving M208 (axis min/max) values in config-override.g possible?

      Has there been a change in rep rap firmware?
      Somehow I'm getting an M208 to the config-override.
      And I don't want it. After a print (or the print is canceled) I'm not able to travel to the initial Z Max

      posted in Using Duet Controllers
      Kiwi 0undefined
      Kiwi 0
    • RE: M17/M18 on Motor 23CL

      @dc42 Thanks, for the answers, will do that!

      posted in General Discussion
      Kiwi 0undefined
      Kiwi 0
    • M17/M18 on Motor 23CL

      Hi!
      I have two 23CL motors in CoreXY configuration, works perfect and super smooth but.
      If I send M18 and then move the printhead to a random position by hand and then sending M17 to enable the motors, the printhead does a randome move in X and Y.
      Is this supposed to happen?

      Is it possible to tell the motors that they are on the correct position and don't have to go to the old position (Old position is never reached by the controller)?

      FW version 3.5.0-rc.3 (Duet 6HC and the 23CL Motors)

      posted in General Discussion
      Kiwi 0undefined
      Kiwi 0
    • RE: Some kind of missuse of toolboards?

      @oliof
      thanks for the fast response!

      Working:

      M308 S2 P"20.temp1" Y"pt1000" ;  
      M950 H2 C"out1" T2                                                 	
      M307 H2 B0 S1.00                                                  
      M307 H2 R3.370 C239.4 D4.28 S1.00 V23.6
      M140 P2 H2
      M143 H2 S300 ; 
      

      if I change M950 to the following line:

      M950 H2 C"20.out0" T2
      

      I'm not able to turn on the heater....

      posted in Duet Hardware and wiring
      Kiwi 0undefined
      Kiwi 0
    • Some kind of missuse of toolboards?

      Hi

      I tried to use the toolboard 1lc to heat a build plate but if I use the ##.out0 to drive the ssr I'm getting the error that now heater is assigned.

      Using an output of the duet3 and the input for the pt1000 on the toolboard works just fine.

      Can the output only be used to heat tools?

      Thank you!

      posted in Duet Hardware and wiring
      Kiwi 0undefined
      Kiwi 0