I just hooked up the duet 2 wifi to my Anycubic Predator and set it up the several prints I did yesterday came out fine no issues. Today I started it up and now its printing uneven on the left side it's almost scrapping the bed on the right side its printing too high. Nothing change all I did was power it down and then turn it on I tried to home the axis then lowered it to correct point then zeroed it out then restart the print but it keeps doing it. Any ideas on why it's doing this and how to fix it?
Best posts made by Kratos
Latest posts made by Kratos
Can anyone assist me?
I have a Hemera install and it says for a duet I should "current setting should be 60% - 90% the rated current of the stepper motor, In the case of Hemera that would mean setting the current to between 0.798 A - 1.197 A." That's what it says on the Hemera page, so show would I set the Duet 2 Wifi current for this?
RE: Ender 3 Duet Wifi not working
I've checked the wiring I've even tried replacing them when I goto the settings and goto the end-stop in the web control when the end stop is not clicked it says no like it should and when I click them they both switch to YES so they are sending the signal but for some reason, it's not stopping the stepper motors and they just keep trying to go.
Ender 3 Duet Wifi not working
I haven't turn my ender 3 pro on for about a week and it homed the axis fine I moved it to another table and tryed to turn it on and this is what happen to have a Duet 2 Wifi. It's like the printer doesn't know when it hits the end stop and the x axis just shakes and doesn't move everything work fine last time it was on. Here a video https://drive.google.com/file/d/13KvlJ7S5f4xp_WLw61MHGZ7yY1HWIakM/view?usp=drivesdk
Duet 2 Wifi and Hemera Help!!
Ok, I finally got my Ender 3 Pro upgraded with the Duet2Wifi and a Hemera but the only problem that I am having now is that for some reason the signals are reversed going to the Hemera I was trying to figure out why it wasn't printing but I could feed filament threw it so I knew it wasn't jammed. I decided to hit the retract button on the DWC and it started extruding! So for some reason when it is supposed to be extruding its retracting and when told to retract its extruding, and I didn't mess with the wires of the Hemera here's a photo of the E0 plug its the Red, Blue, Green, and Brown wired plug.
RE: M21: Cannot initialise SD card 0: Card is unusable<LF>ok<LF>
Ok I tryed the ad card formatted on original sd card and 2 other and still getting that and it even tells me that there isn't even a sd card in there when there is. Here's a close up if the ad reader on board you asked for.
M21: Cannot initialise SD card 0: Card is unusable<LF>ok<LF>
I've just received my Duet 2 Wifi board and have been working on this all day and come to find out after rewiring the whole machine that when I run M21 it tells me "M21: Cannot initialize SD card 0: Card is unusable<LF>ok<LF>" and now I'm stuck cause when I try to go to the web interface it tells me "Your Duet rejected the HTTP request: page not found Check that the SD card is mounted and has the correct files in its /www folder". So basically I can do nothing? I dunno why it needs the SD card to use the web interface in the first place I'd think all that would be part of the firmware on the board. Is there anything I can do OTHER then asking for a new board cause that's gonna take forever.