Topics created by manne_sahne

On the github they write:

USB communication Keep the usb connection is ok between the MKS THR36/42 and your Klipper host board, and power on. SSH login to your Klipper console and run ls /dev/serial/by-id/*

If this should work, is it possible to use a USB Hub to connect the toolboard and the Raspberry Pi to the duet?

my prints also have bulging corners which has been present for a few months. I followed the other topic thread about pressure advance issues which has many responses and discussion but no definitive resolution. I have luck by printing much faster than i normally would and the corners are better.