Posts made by MightyRaith

@Macgyver How did you resolve that did you have to use the gnd pin on a nearby IO for the other earth?

I cannot for the life of me get the CR-Touch to work with my Duet Mini 3 5+ When the printer is turned on the probe does NOT self check but flashes red - Reset probe macro does reset the probe to a purple light.

Using deployprobe.g causes it to revert to red flashing

Once in a blue moon I am able to use the deploy and retract macros to move the probe but only for a few mins and then it goes back to flashing red.

Ender 5 Pro
RepRapFirmware 3.3
Updated web controls 3.3
Duet 3 Mini 5+
Direct-Drive Extruder

(Not my image but wires are in same order this was just better pic than I had taken)

@jay_s_uk Just joined up getting a bit late here but when I finish work tomorrow I'll be able to have more of a good look at the discord chan. Also thread suddenly decided to post there not sure what changed but hey ho.

After a small accident with my BTT SKR Mini E3 board where I accidently burnt out a mosfet I decided to try embracing the world of RepRap I have managed to get the setup to the point where I can print but I'm having huge issues with the Z height.

Coming from Marlin I was initially a bit confused as to Z Offset and how this works in RepRap the problem I am having is no matter how many times I try guides such as https://duet3d.dozuki.com/Wiki/Test_and_calibrate_the_Z_probe]When I start a print I always have to start rapidly baby stepping the Z offset.

I'm still not convinced I really understand Z Trigger height and if I still need a Z offset? Also my trigger height seems to be higher than what the guides seem to suggest mines comes up as approx 3mm

I have mild Aspergers so sometimes I cannot see the obvious so please do not worry about offending me I'm quite happy having anything explained to me as you would a child lol - If anyone has good Ender 5 configs I can pinch I'd be very grateful or any suggestions as to the many mistakes I've no doubt made!

Printer:: Creality Ender 5 Pro (Cartesian)
Mainboard: BTT Mini SKR RRF
Hotend: E3D Hemera
Firmware: Duet Web Control 3.3.0-rc3

homez.g homeall.g config-override.g config.g

@jay_s_uk It does I only added the tag to see if the lack of one was what it was objecting to

@jay_s_uk Still same issue

Trying to post a help request but I keep getting a little pop up with forbidden. Is it me that's forbidden or what I'm trying to do?

@xtarr The advise re the PID tune is definately worth looking into for sure.

@macgyver Glad you got it all sorted