People, I solved the problem. I add a new line iin my config.g a PanelDue port: M575 P1 S1 B57600. Nos its Works fine.
Best posts made by Milke
RE: Attempt to move motors when VIN is not in range
I discovered the electronic component that was damaged, it was a 47K resistor (R80) of the voltage divider (PWR_FAIL_DET2).
I replaced the resistor with another resistor and my machine returned to normal!
RE: Bed Heater Error
I solved my problem, I add the command M501 at the end of my config.g.
I use in my Duet2WiFi the firmware version 3, RepRapFirmware Configuration Tool v2.1.8.
I made the autotune in the BED and I add the Heater model parameters at the config-override.g.
Now it's working well, thanks for the support.
thank you for your support. I read your previous recommendations on the topic.